A1 Cardone 65-6010 Drive Shaft in Canada

Buyer fitment guide only intended as reference. Please use catalogue search by vehicle to ensure proper fitment.

Nissan 37000CA00A

CARDONE Remanufactured Prop Shafts are engineered using the most stringent quality processes to deliver smooth, consistent performance in any driving condition. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Additionally, all CARDONE Prop Shafts are 100% dynamically balanced, resulting in vibration-free performance at all speeds.
Built to match O.E. form, fit and function.
100% NEW universal joints are installed to ensure proper fit and optimal performance.
All slip yokes are lubricated to prevent premature wear.
Units are 100% dynamically balanced at 3200 RPMs for vibration-free operation and increased joint life.

Drive Shaft Type	Universal Joint
Greasable	No
Package Contents	Prop Shaft; Instruction Sheet
E-Waste	No
Prop 65	No
SDS Required	No
Contains Electronic Components?	No
Is item a chemical?	No
Is or contains a battery?	No
Is or contains a bulb?	No
Is the item CARB affected?	No
FAQ_Q1	What causes prop shaft vibration?
FAA_A1	The most common causes of prop shaft vibrations are worn joints, an unbalanced drive shaft, poor joint lubrication, and a bent or twisted shaft.
FAQ_Q2	Are your shafts balanced? Why is it necessary?
FAA_A2	Each shaft is precisely balanced before boxing. Prop shaft balance is necessary for proper driveline operation. An unbalanced shaft can cause premature wear on other major components such as your transmission and rear differential.
FAQ_Q3	How is a prop shaft balanced?
FAA_A3	This procedure entails the distribution of mass in the rotating prop shaft. The shaft is measured and altered where necessary to ensure that vibration does not occur during operation.
FAQ_Q4	Do all vehicles have prop shafts?
FAQ_Q5	What is prop shaft phasing?
FAA_A5	Phasing is a used to describe the alignment of the yokes with each other at both ends of the prop shaft. The phase angle is the rotational position of each yoke on a prop shaft.
FAQ_Q6	What is a universal joint?
FAA_A6	A universal joint is designed to allow prop shafts to move with suspension travel while the shaft is moving. This allows power to be transmitted when the prop shaft is angled between the transmission and differential.
FAA_A4	Not all vehicles will have a prop shaft. Prop shafts are most commonly found on all-wheel-drive and rear- wheel-drive vehicles.
Product Condition	New
UPC	00884548302365
Origin Country:	CN
Weight:	33.56Lb. (15.25 kg.)
Package Dimensions:	91.5" x 10.1" x 5.8" (232.4 cm x 25.7 cm x 14.6 cm)

1 Year Warranty

A1 Cardone 65-6010 Drive Shaft

Remanufactured Driveshaft / Prop Shaft