Cardone Select 6E-2005 Fuel Injection Throttle Body in Canada

Buyer fitment guide only intended as reference. Please use catalogue search by vehicle to ensure proper fitment.

Honda 16400RX0A01
Honda 16400R44A01
Honda 16400R44A02
Acura 16400RLGJ01
Acura 16400RX0A01
Honda 16400R11A01
Honda 16400RLGJ01
Acura 16400R11A01
Acura 16400R44A01
Acura 16400R44A02

All CARDONE 100% New Electronic Throttle Bodies are guaranteed to fit and function like the original due to our proprietary engineering standards. Each unit is built and tested as a complete assembly to ensure quick installation and reliable performance. All components match O.E., ensuring accurate air flow in all driving conditions and peak engine performance.
100% computerized testing of motor, throttle position sensor and articulation ensures reliable and consistent performance.
Critical components used in manufacturing the electronic throttle body, including the housing, throttle plate, position sensors, throttle actuator motor and throttle plate return spring conform to precise O.E. dimensions.
Each throttle body is tested for all critical functions, including response time and air flow at multiple points, ensuring an optimal fuel/air ratio.

Terminal Type	Blade
Package Contents	Electronic Throttle Body; Instruction Sheet
Product Condition	New
E-Waste	Yes
Prop 65	No
SDS Required	No
Contains Electronic Components?	Circuit Board
Is item a chemical?	No
Is or contains a battery?	No
Is or contains a bulb?	No
Is the item CARB affected?	No
FAQ_Q1	Are your new throttle bodies the same design as O.E.?
FAA_A1	The new electronic throttle body is engineered and manufactured to match the O.E. design.
FAQ_Q2	Will I have to modify anything on the vehicle to install your new throttle body?
FAA_A2	When installing the new electronic throttle body, there is no need to modify the vehicle for installation.
FAQ_Q3	Whatâ€™s an Electronic Throttle body?
FAA_A3	The electronic throttle body is a powertrain component that has a plate, motor, and integrated position sensors which are utilized to regulate the amount of air entering the engine by opening the throttle valve to a desired angle via commands from the vehicleâ€™s powertrain control module or throttle actuator control module.
FAQ_Q4	What happens when an Electronic Throttle Body fails?
FAA_A4	When an electronic throttle body fails, the controlling module will illuminate the MIL/SES/CEL. The module will then activate a fail-safe mode operation and gradually reduce the engineâ€™s speed back to an idle RPM.
FAQ_Q5	What causes the Electronic Throttle Body to fail?
FAA_A5	The most common failure in an electronic throttle body is the integrated throttle position sensor. The ETB is equipped with high and low voltage reference throttle position sensor for redundancy. Either one of these sensors could fail, or possibly both.
FAQ_Q6	Is there anything that has to be done after installing the replacement throttle body?
FAA_A6	A relearn calibration procedure is necessary after installation of replacement throttle body.
FAQ_Q7	Can I purchase a throttle body with a bigger bore to increase horsepower and improve my throttle response?
FAA_A7	Swapping your throttle body for one with a bigger bore is not recommended. The throttle bodies we sell are specific to the application.
FAQ_Q8	Do you sell throttle body spacers?
FAA_A8	We do not sell throttle body spacers, nor do we recommend the use of a spacer.
FAQ_Q9	The O.E. throttle body has coolant hoses attached. Whatâ€™s the purpose?
FAA_A9	The purpose of the attached coolant hoses is to keep the throttle body warm by the transfer of heat from the coolant to the housing, preventing moisture from freezing between the throttle body bore and throttle valve during extreme cold temperatures.
FAQ_Q10	Is it ok to bypass the coolant hoses?
FAA_A10	No, bypassing the coolant hoses is not recommended. There are cases where we sell units without coolant pipes, because we are following O.E. supersessions where the pipes have been removed. Instructions are provided for rerouting coolant hoses.
FAQ_Q11	Do all throttle bodies have an ice-breaker mode for extreme cold starts?
FAA_A11	Not all throttle bodies have this feature, where the throttle valve is reversed from its normal movement by the control module, which breaks up any ice formation between the throttle bore and valve. This feature is based on application.
FAQ_Q12	What else does the throttle body control other than idle air bypass and acceleration throughout driving range?
FAA_A12	The throttle body is also part of the cruise control, traction control, stability control, and pre-crash systems, as well as other systems that require engine torque management.
UPC	00884548334373
Origin Country:	CN
Weight:	2.98 lbs (1.36 kg)
Package Length:	9.6" (24.3 cm)
Package Width:	7.3" (18.4 cm)
Package Height:	5.3" (13.3 cm)

1 Year Warranty

Cardone Select 6E-2005 Fuel Injection Throttle Body

New Fuel Injection Throttle Body