| E-Waste | No |
| California Proposition 65 | Y |
| Surface Finish | Coated |
| Friction Material | NA |
| Bleeder Screw Thread | M10X1.00 |
| Caliper Configuration | Friction Ready |
| Caliper Piston Diameter | 1.490 |
| Caliper Piston Diameter | 37.846 |
| Manufacturing Type | Remanufactured |
| Caliper Bracket Mounting Hole Size | 12 |
| Caliper Bracket Mounting Hole Thread Pitch | 1.75 |
| Caliper Piston Diameter A | NA |
| Caliper Piston Diameter B | NA |
| Bleeder Screw Cap Included | No |
| Dust Boots Included | Yes |
| Casting Number 1 | GJS 121, GJS 262 |
| Caliper Bracket Surface Finish | Coated |
| Is Or Contains A Battery | No |
| Is Item A Chemical | No |
| Contains Electronic Components | No |
| Is Or Contains A Bulb | No |
| FAQ_Q1 | Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa? |
| FAA_A1 | Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations. |
| FAQ_Q2 | What type of fluid should I use: DOT 3, DOT 4, or DOT 5? |
| FAA_A2 | As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container. |
| FAQ_Q3 | Car pulls to one side during braking. Why? |
| FAA_A3 | Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation. |
| FAQ_Q4 | Brakes squeal all of the time. What's causing the squeal? |
| FAA_A4 | Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish. |
| FAQ_Q5 | Could calipers be the cause of a low brake pedal? |
| FAA_A5 | A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder. |
| FAQ_Q6 | What type of grease is used on floating caliper mounting pins? |
| FAA_A6 | A silicone grease is used on floating caliper mounting pins. |
| FAQ_Q7 | Do all of your Calipers come with the new hardware and a mounting bracket for installation? |
| FAA_A7 | New hardware and Brackets are included with all of our Calipers when applicable. Mounting bracket inclusion is dependant on the application. Mounting Brackets are also sold separately for most applications. |
| Does it Require SDS | No |
| Is Prop Sixty Five Affected | Yes |
| Is the item CARB affected | No |
| UPC | 00887213470031 |
| Origin Country: | MX |
| Weight: | 9.66 lbs (4.39 kg) |
| Package Length: | 9.6" (24.4 cm) |
| Package Width: | 7.8" (19.8 cm) |
| Package Height: | 5.6" (14.2 cm) |
