Cardone Select 83-113 Transfer Case Motor
New Transfer Case Motor
$605.90
$337.38
Out of Stock
Brand: Cardone Select
Stock #: 83113
Condition: New
UPC: 884548215306
Weight: 5 lbs (2.28 kg)
Accepted Payments: Visa, MasterCard, PayPal
Buyer fitment guide only intended as reference. Please use catalogue search by vehicle to ensure proper fitment.
- Dodge 5170543AA
- Chevrolet 12384980
- Chevrolet 88962314
- GMC 12384980
- GMC 88962314
- Building on decades of experience using reverse engineering to remanufacture automotive motors, CARDONE engineers have meticulously designed and tested our brand-new transfer case motors to match O.E. fit and performance. Each unit is load-tested to ensure the torque power specification meets industry standards. As a direct-fit O.E. replacement, CARDONE New Transfer Case Motors provide ease of installation and reliability you can count on.
- All critical components are tested to guaranteelike-new performance.
- All replacement components are O.E. quality.
- Original design weaknesses are corrected to make alonger lasting part.
- Units are computer tested, both as sub-assembliesand as complete units to ensure reliability.
| Contains Electronic Components? | No |
| E-Waste | Yes |
| FAA_A1 | Do not operate the motor while it is off the transfer case. This can damage the motor and set an error code that must be cleared before the motor will operate again. Shift the transfer case into the position of the motor to install. |
| FAA_A2 | Yes, the transfer case should be manually shifted into the two-wheel drive position at the shift shaft before the installation of the replacement motor. Typically the positions are spring-loaded and can be rotated manually. |
| FAA_A3 | A crescent wrench can be used for this operation. |
| FAA_A4 | The replacement motor drive is factory-set in the 2 wheel drive position. |
| FAA_A5 | This may be caused by a transfer case control module calibration issue. Check for DTC's and calibration version − there may be a software update from the Original Equipment Manufacturer. If the motor attempts to shift, but sounds weak, check the front axle lock actuator. If the axle lock does not engage, the motor cannot complete its engagement. |
| FAQ_Q1 | The replacement motor drive is in a different position, can I reposition before installing? |
| FAQ_Q2 | Can I install the replacement motor if my Transfer Case motor failed in 4 Wheel Drive Low or High? |
| FAQ_Q3 | What tool can I use to manually shift the transfer case into the two-wheel drive position before I install the replacement motor? |
| FAQ_Q4 | What drivetrain position is the replacement motor drive placed in? |
| FAQ_Q5 | The Service 4WD light is on and/or the 4WD is inoperative. What could cause this condition? |
| Gear of Chain Type | Gear |
| Grade Type | Performance |
| Is item a chemical? | No |
| Is or contains a battery? | No |
| Is or contains a bulb? | No |
| Is the item CARB affected? | No |
| Package Contents | Transfer Case Motor; Instruction Sheet |
| Product Condition | New |
| Prop 65 | No |
| SDS Required | No |
| Shift Operation Type | Electronic |
| UPC | 884548215306 |
| Origin Country: | CN |
| Weight: | 5 lbs (2.28 kg) |
| Package Length: | 11.9" (30.2 cm) |
| Package Width: | 7.6" (19.4 cm) |
| Package Height: | 7.1" (18.1 cm) |
1 Year Warranty