Cardone Select 83-1002 Transfer Case Motor in Canada

Buyer fitment guide only intended as reference. Please use catalogue search by vehicle to ensure proper fitment.

Land Rover IGH500040
Mercedes-Benz 1645400188

Building on decades of experience using reverse engineering to remanufacture automotive motors, CARDONE engineers have meticulously designed and tested our brand-new transfer case motors to match O.E. fit and performance. Each unit is load-tested to ensure the torque power specification meets industry standards. As a direct-fit O.E. replacement, CARDONE New Transfer Case Motors provide ease of installation and reliability you can count on.
All critical components are tested to guaranteelike-new performance.
All replacement components are O.E. quality.
Original design weaknesses are corrected to make alonger lasting part.
Units are computer tested, both as sub-assembliesand as complete units to ensure reliability.

Contains Electronic Components?	No
E-Waste	Yes
FAA_A1	Do not operate the motor while it is off the transfer case. This can damage the motor and set an error code that must be cleared before the motor will operate again. Shift the transfer case into the position of the motor to install.
FAA_A2	Yes, the transfer case should be manually shifted into the two-wheel drive position at the shift shaft before the installation of the replacement motor. Typically the positions are spring-loaded and can be rotated manually.
FAA_A3	A crescent wrench can be used for this operation.
FAA_A4	The replacement motor drive is factory-set in the 2 wheel drive position.
FAA_A5	This may be caused by a transfer case control module calibration issue. Check for DTC's and calibration version âˆ’ there may be a software update from the Original Equipment Manufacturer. If the motor attempts to shift, but sounds weak, check the front axle lock actuator. If the axle lock does not engage, the motor cannot complete its engagement.
FAQ_Q1	The replacement motor drive is in a different position, can I reposition before installing?
FAQ_Q2	Can I install the replacement motor if my Transfer Case motor failed in 4 Wheel Drive Low or High?
FAQ_Q3	What tool can I use to manually shift the transfer case into the two-wheel drive position before I install the replacement motor?
FAQ_Q4	What drivetrain position is the replacement motor drive placed in?
FAQ_Q5	The Service 4WD light is on and/or the 4WD is inoperative. What could cause this condition?
Gear of Chain Type	Gear
Grade Type	Performance
Is item a chemical?	No
Is or contains a battery?	No
Is or contains a bulb?	No
Is the item CARB affected?	No
Package Contents	Transfer Case Motor; Instruction Sheet
Product Condition	New
Prop 65	No
SDS Required	No
Shift Operation Type	Electronic
UPC	00884548304048
Origin Country:	CN
Weight:	2.98 lbs (1.36 kg)
Package Length:	5.5" (14 cm)
Package Width:	4.6" (11.8 cm)
Package Height:	9.5" (24.1 cm)

1 Year Warranty

Cardone Select 83-1002 Transfer Case Motor

New Transfer Case Motor