A1 Cardone 40-148 Windshield Wiper Motor
Remanufactured Windshield Wiper Motor
Brand: A1 Cardone
Stock #: 40148
Condition: Remanufactured
UPC: 082617039727
Weight: 5.81 lbs (2.64 kg)
Accepted Payments: Visa, MasterCard, PayPal
Buyer fitment guide only intended as reference. Please use catalogue search by vehicle to ensure proper fitment.
- As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
- Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
- Each unit has its main components tested or gauged against the O.E. standard. [Armature, Field, Bearing, Parking switch, or pulse board] €“ Then the final product is tested for each of its functions on the vehicle.
- Every motor bearing is re-impregnated or replaced as needed.
- Lubrication is applied to the output gear to provide maximum load capacity and long life.
- Motor magnets are 100% recharged for performance and reliability.
- Weak solder points are 100% reflowed to extend life expectancy.
- CARDONE's legacy began in 1970 when its first product offering was released ˆ’ Remanufactured Wiper Motors. Since then, the CARDONE name has become synonymous with high-quality, remanufactured products. Every CARDONE wiper motor is re-engineered, built and tested to match O.E. performance. For nearly half a century, CARDONE Remanufactured Wiper Motors have provided rock-s olid reliability that you can trust for the long haul.
| Product Condition | Remanufactured |
| Package Contents | Wiper Motor; Instruction Sheet; Nut; Alignment Tool |
| Prop 65 | No |
| SDS Required | No |
| Contains Electronic Components? | Electric Motor |
| Is item a chemical? | No |
| Is or contains a battery? | No |
| Is or contains a bulb? | No |
| Is the item CARB affected? | No |
| E-Waste | Yes |
| FAQ_Q1 | The wiper motor continues to stop in the middle of the windshield. What’s causing this to happen? |
| FAA_A1 | If the motor does not have hidden wiper blades, the most likely cause of parking misalignment is the crank arm position. Adjust the crank arm angle on the motor shaft to park wipers at bottom of windshield. Refer to a vehicle specific service manual or online material for the “hidden park†reset procedure. |
| FAQ_Q2 | I just installed a new wiper motor and put my old washer pump on and the motor does not work. Is the motor defective? |
| FAA_A2 | The motor is NOT defective. There are some wiper motors that will not operate if the washer pump is defective. This may be the cause of the original motor problem. Bench test wiper motor and washer pump before replacing either. |
| FAQ_Q3 | Why won’t the wiper motor work? I have everything hooked up properly. |
| FAA_A3 | Check the wiring harness ground, terminal ground lug or ground strap. If the motor still does not operate properly, check the switch and switch circuit. |
| FAQ_Q4 | How can I determine if my vehicle is equipped with a moisture sensitive wiper motor? |
| FAA_A4 | Most vehicles equipped with this feature have a rain sensor permanently mounted to the inside of the windshield in front of the rear view mirror. |
| FAQ_Q5 | How do moisture sensitive wipers work? |
| FAA_A5 | A moisture sensor monitors rainfall accumulation on the windshield and provides input to the windshield wiper motor control module. The windshield wiper control module adjusts the wiper motor speed accordingly. |
| UPC | 082617039727 |
| Origin Country: | MX |
| Weight: | 5.81 lbs (2.64 kg) |
| Package Length: | 6.8" (17.1 cm) |
| Package Width: | 5.1" (13 cm) |
| Package Height: | 10.8" (27.3 cm) |
1 Year Warranty